Home Auto Pilot Flight Controller Mauch Sensor Hub HEX X2 V2 PL/PC Series Power Module Enclosure

Mauch Sensor Hub HEX X2 V2 PL/PC Series Power Module Enclosure

$65.00

Add to Cart:

Description
Details
Reviews

Features
MAUCH 010 : PL - Sensor Hub X2 / With CFK Enclosure
This sensor hub is to connect two PL-xxx current sensors in parallel.
The current of both sensors will be summarized and passed to the FC.
The voltage measurement of the Lipo packs will be collected from both
sensors and passed through the Hub to the FC. The main purpose of
this hub is to replace existing protection circuits ( like an ideal diode )
and to monitor, that both paralleled Lipo's supply the same current
to the system. Since we monitor the current of both batteries,
we will find out very early when a Lipo starts to fail ?
before it is too late. If the difference in current is larger
than + / -15 %, the Alarm output will be ON to indicate the fault?
the pilot should immediately land and check the batteries.
The I2C bus is for future integration.
Product Details
To set up a complete system you would need：
1x PL Sensor Hub X2
2x Current sensor board:
2x PL-050 = 2x50A = 0-100A Total
2x PL-100 = 2x100A = 0-200A Total
2x PL-200 = 2x200A = 0-400A Total
1x Power supply, which can be any of the Premium-line
series BEC's 39mm x 31mm x9mm / 7g without cables and
without enclosure 42mm x 34mm x 10mm / 13g with enclosure
and without cables Delivery in PP box: 55 x 55 x 20mm / 27g
Scope of delivery:
1x PL Sensor Hub X2
1x CFK enclosure
2x Sensor cable / Molex 1.25mm - 4p / L = 150mm
1x Alarm output cable / Molex 1.25mm-3p / L = 100mm
MAUCH010
HEX Mauch Sensor Hub X2 V2 PL/PC Series Power Module With CFK Enclosure For Pixhawk2 PIX Flight Control RC Drone

HEX Mauch Sensor Hub X2 V2 PL/PC Series Power Module With CFK Enclosure For Pixhawk2 PIX Flight Control RC Drone