Home BRUSHLESS GIMBAL PTZ Control Basecam Electronics CAN_Driver CAN-enabled SimpleBGC32 control

Basecam Electronics CAN_Driver CAN-enabled SimpleBGC32 control

$199.00

Add to Cart:

Description
Details
Reviews

Features
Motor driver with the CAN-bus interface is intended
to be used with the CAN-enabled SimpleBGC32 controller.
build a 3-axis stabilizer based on a modular scheme
2axis 3axis, 4th, 5th axis, with the optimized wiring
between modules that is perfectly immune to EMI noise.
This module was designed for use with the "extended" controllers
(Extended, Pro, CAN_MCU, OEM), replacing the onboard drivers.
Requires basecam electronics firmware version 2.66b1 or higher.
Product Details
The kit includes:
CAN_Driver controller
CAN Wire 50 cm
Header Pin Strip RST2x14
Size of the board 50×30 mm, with capacitor 60.5×31.5mm
Weight 11.50 g PCB with capacitor
Power supply voltage 6–26 V (2s - 6s LiPo)
6–40 V (2s - 9s LiPo) 6–52 V (2s - 12s LiPo)
Maximum motor current 15A continuous
(with heatsink installed),
max. 40A impulse 30A continuous (with heatsink installed),
40A short-time 20A continuous (with heatsink installed),
40A short-time Current sensor max. range adjustment NO 15A
or 45A via solder able jumpers SW5-SW7
Driver supports a big number of models of absolute
rotary encoders with the following interfaces:
SPI, PWM ,I2C, A, B, Z
SSI, BiSS-C (3v3, RS422)
Main controller connection: 2x CAN, optional onboard terminator
Other interfaces: Limit switch, Z-Index switch,
Emergency switch, and several digital I/O pins
1-wire for thermal sensor connection
Address selection pins
Serial port for "Serial-over-CAN" function
Protections:
Over-current
Under-voltage
Short-circuit
Over-temperature
Over-voltage (surge protection)
Basecam Electronics CAN_Driver CAN-enabled SimpleBGC32 controller

Basecam Electronics CAN_Driver CAN-enabled SimpleBGC32 controller