brushlessgimbal.ca
Categories
Aerial Photography CUSTOM UAV AR
Auto Pilot Flight Controller
BRUSHLESS GIMBAL PTZ
Control
Digital SLR
Gimbal Brushless Motor
Gimbal Motor Cages
Gimbal Mounting
GoPro
Carbon fiber parts & fasteners
Cinematography & UAS Rentals
Cinestar Parts
Electric air craft Motor & ESC
Fasteners stand off Nuts & Bolts
FPV
Multicopter Propeller
Multi Rotor Products & Parts
250 Rasing Quad Hexa Products
Brushless Motor
ESC
Frame
Multi Rotor ARTF & KIT RC Craft
Parts
Battery & Balance Charger
Transmitter & Receiver
RTF ready to play kits
3D printer & Filament
WHolesale
Servo actuator
Remote ID Drone tracking system
Power Generator FUEL CELL
Information
Customer Service
About Us
Log In / Register
Create Account
Shipping & Returns
Privacy Notice
Conditions of Use
General Info
Site Map
Gift Certificate FAQ
Discount Coupons
Newsletter Unsubscribe
Useful Links
Contact
0 - $0.00
Log In / Register
0 - $0.00
Currencies
US Dollar
Euro
GB Pound
Canadian Dollar
Australian Dollar
Categories
Aerial Photography CUSTOM UAV AR
37
Auto Pilot Flight Controller
291
BRUSHLESS GIMBAL PTZ
369
Carbon fiber parts & fasteners
142
Cinematography & UAS Rentals
30
Cinestar Parts
109
Electric air craft Motor & ESC
24
Fasteners stand off Nuts & Bolts
47
FPV
370
Multicopter Propeller
160
Multi Rotor Products & Parts
761
Battery & Balance Charger
129
Transmitter & Receiver
213
RTF ready to play kits
88
3D printer & Filament
26
WHolesale
106
Servo actuator
156
Remote ID Drone tracking system
3
Power Generator FUEL CELL
18
Specials ...
New Products ...
Featured Products ...
All Products ...
Home
Auto Pilot Flight Controller
Pixhawk 5XAutopilot Flight Controller PM02D Power Module M8N GPS
Pixhawk 5XAutopilot Flight Controller PM02D Power Module M8N GPS
$360.00
Add to Cart:
Description
Details
Reviews
Features
* Modular flight controller: separated IMU, FMU, and Base system connected by a
100-pin & a 50-pin Pixhawk® Autopilot Bus connector, designed for flexible and customizable systems
* Redundancy: 3x IMU sensors & 2x Barometer sensors on separate buses, allowing parallel
and continuous operation even in the event of a hardware failure
* Triple redundancy domains: Completely isolated sensor domains with separate buses
and separate power control
* Newly designed vibration isolation system to filter out high frequency vibration
and reduce noise to ensure accurate readings
* Ethernet interface for high-speed mission computer integration
* Automated sensor calibration eliminating varying signals and temperature
* IMUs are temperature-controlled by onboard heating resistors, allowing optimum working
temperature of IMUs
* Two smart batteries monitoring on SMBus
* Additional GPIO line and 5V for the external NFC reader
* Secure element for secure authentication of the drone (SE050)
Product Details
Technical specification
* FMU Processor: STM32F765
* 32 Bit Arm® Cortex®-M7, 216MHz, 2MB memory, 512KB RAM
* IO Processor: STM32F100
* 32 Bit Arm® Cortex®-M3, 24MHz, 8KB SRAM
* On-board sensors
* Accel/Gyro: ICM-20649
* Accel/Gyro: ICM-42688P
* Accel/Gyro: ICM-20602
* Mag: BMM150
* Barometer: 2x BMP388
Electrical data
* Voltage Ratings:
* Max input voltage: 6V
* USB Power Input: 4.75~5.25V
* Servo Rail Input: 0~36V
Mechanical data
* Dimensions
* Flight Controller Module: 38.8 x 31.8 x 14.6mm
* Standard Baseboard: 52.4 x 103.4 x 16.7mm
* Weight
* Flight Controller Module: 23g
* Standard Baseboard: 51g
Interfaces * 16- PWM servo outputs
* R/C input for Spektrum / DSM
* Dedicated R/C input for PPM and S.Bus input
* Dedicated analog / PWM RSSI input and S.Bus output
* 4 general purpose serial ports
* 3 with full flow control
* 1 with separate 1A current limit
* 1 with I2C and additional GPIO line for external NFC reader
* 2 GPS ports
* 1 full GPS plus Safety Switch Port
* 1 basic GPS port
* 1 I2C port
* 1 Ethernet port
* Transformerless Applications
* 100Mbps
* 1 SPI bus
* 2 chip select lines
* 2 data-ready lines
* 1 SPI SYNC line
* 1 SPI reset line
* 2 CAN Buses for CAN peripheral
* CAN Bus has individual silent controls or ESC RX-MUX control
* 2 Power input ports with SMBus
* 1 AD & IO port
* 2 additional analog input
* 1 PWM/Capture input
* 2 Dedicated debug and GPIO lines
HL-5X-M8N
100 Units in Stock
Be the first to write a review.
Write a Review.
Product 221/291
Previous
List
Next
This product was added to our catalog on Friday 17 December, 2021.
Customers who bought this product also purchased...
BGC Encoder Motor PM2804 AS5048A encoder built inside
BGC Encoder Motor PM2205 AS5048A or 5600 encoder built inside
Pixhawk 5XAutopilot Flight Controller PM02D Power Module M8N GPS
Shop
Home
Featured
Specials
New Arrivals
View All
Customer Service
Shipping and Returns
Contact Us
About Us
My Account
Copyright © 2024
Brushlessgimbal.ca
. Powered by
Zen Cart
.
Responsive Zen cart templates
by Picaflor Azul.
Content
Custom Left Slide Out
You can add any content here, text, images, etc.